|
The highest quality threads with increased tensile
strength are produced by cold rolling the thread forms.
There is a screwdriver slot provided at the end of each
thread of the short version and in the long threaded end of
the long version. With the aid of a coin or screwdriver,
the Dual Threaded Adapter Screw can be securely
tightened into its mating part.
The long version of these Dual Threaded Adapter Screws
(Table #2) have an overall length of 2.5 inches (76.2mm).
The table, or short end thread, is 3/4 inch (1.9cm) long;
and the M10x1.5 thread is 1.75 inches (44.5 mm) long,
except the 1/4 inch-20 to M10x1.5, where the 1/4 inch
diameter thread is only 1/2 inch (13mm) long.
If one of these fourteen combinations
does not meet your requirements, we will be pleased to
supply any other combination on special order.
|
